CONNECTIVITY

High Speed Camera Networking

A high speed camera used independently is a valuable tool, but many applications require more than one. Networks of high speed cameras that require only one trigger input and are frame synchronised are the most powerful and efficient way to capture events from multiple angles. frame sync is essential if the image are to be used for 3D analysis (using TrackImage software for instance)

Range

We offer several options for networking, so however many high speed cameras you have, there’s an ideal solution for your application.

Wireless Networking

High speed cameras can even be networked with no cabling is needed. Several IDT high speed cameras can have GPS or IRIG, allowing frame synchronisation with no physical connection between the cameras.

 IEEE1588 PTP HUB

The IEEE1588 PTP HUB is a fully portable, compact and rugged appliance, designed to provide Precision Timing over Giga Ethernet and synchronizes any IEEE1588 supported device that shares the same network.

Part Number: 1425-0100

IEEE1588 PTP HUB

High G Rack Hub

The High-G Rack Hub system is designed to provide a complete infrastructure solution for on-board vehicular testing, or when full autonomy from the testing infrastructure is required. The system consolidates and integrates the operation of a network of cameras and lighting in a single, highly compact, lightweight, configurable appliance.

Part Number: 1140-0100

High G Rack Hub

MINI HUB

The miniHUB provides the ability to power, control, synchronize, and trigger up to three iNdustrial, NX-Air, OS, Airborne, or CrashCam model cameras simultaneously via Ethernet or WiFi. Its small form factor is perfect for on-board applications and can be controlled wirelessly via its built-in WiFi Router.


NX HUB

The NX HUB provides the ability to power, control, synchronize, and trigger up to six NX Series model cameras simultaneously via Ethernet or WiFi and can be purchased separately or with its 24V power supply.


NX-AIR HUB

The NX-Air HUB provides the ability to power, control, synchronize, and trigger up to 6 iNdustrial, NX-Air, OS, Airborne, or CrashCam model cameras simultaneously via Ethernet or WiFi. Its built-in battery provides the ability to run autonomously while connected to NX-Air model cameras.


TC30 Hub

The TC30 is a compact, ruggedised, battery powered hub. There are two configurations: Either providing the ability to power, control, synchronise, and trigger up to 4 iNdustrial, NX-Air, OS, Airborne, CrashCam model cameras via Ethernet, or CrashCam Mini cameras, using USB3.0.


© 2018 IDT Europe. All rights reserved. Specifications are subject to change without notification.